
KT690 Family
Allows BIOS to skip certain test while booting in
order to decrease boot time.
Disabled: Displays normal POST messages.
Enabled: Displays OEM Logo (no POST messages).
Set display mode for Option ROM.
Select Power-on state for numlock
Enabled
Select support for PS/2 Mouse.
Wait for ‘F1’ If Error
(see note)
Wait for F1 key to be pressed if error occurs.
Hit ‘DEL’ Message Display
Displays “Press DEL to run Setup” in POST.
Enabled: Allows option ROMs to trap interrupt 19
Enabled
Control the default beeps during boot of the system.
This setting will aldo control the beep during
enumeration and (un)plug of USB.
0->4->3->5->1->2
1->2->3->5->0->4
3->5->1->2->0->4
3->0->4->1->2->5
2->1->0->4->3->5
2->0->4->3->1->5
The numbers in the sequence means:
0 = “Removables” (Floppy, LS100 etc.)
1 = “Hard Disk”
2 = “ATAPI CDROM”
3 = “BEV/onboard LAN”
4 = “USB” (any bootable USB device)
5 = “External LAN” (PCIe/PCI LAN card)
Primary IDE Master
Primary IDE Slave
Third IDE Master
Third IDE Slave
Fourth IDE Master
Fourth IDE Slave
Does override current boot setting. Device must be
in the boot priority menu though. If the device fails to
boot, the system will NOT try other devices.
Note: List of errors:
Primary Master Hard Disk Error
Interrupt Controller-1 error
PCI IRQ routing table error
Halt on Invalid Time/Date
Komentáře k této Příručce