Kontron AM4150 U-Boot Bootloader Uživatelský manuál stáhnout pdf (Strana 37)

AM4150 U-Boot Bootloader U-Boot Usage

ID 1052-5678, Rev. 1.0 Page 37

P R E L I M I N A R Y

6.2.2.2 sconf select

To change the setting, invoke the “sconf select” command.

Example:

6.2.2.3 sconf set

The setting of the chosen base configuration can be changed via the “sconf set” command. If

the “sconf set” command is invoked without parameters, all changeable options are shown. In

the following example, first, all possible settings are shown, and then the Ethernet interface

FM1@DTSEC4 is changed from the AMC port 1 to the front Ethernet connector J2 (GbE B).

=> sconf select 2

New base configuration 2

=> sconf set

Board’s Port Configuration:

Option

Setting | Value # command, option <and parameter>

-------------------------------------------------------------

DTSEC4 routing : port1 # sconf set dtsec4 <port1 | front>

SRIO Sys.Size : large # sconf set srio <small | large>

SRIO mode : agent # sconf set srio <agent | host >

AMC Port Activation / Forced settings (ignoring E-Keying):

Option

Setting | Value # command, option <and parameter>

-------------------------------------------------------------

Port 2 : auto # sconf set port 2 <auto | disable | enable>

Port 4 : auto # sconf set port 4 <auto | disable | enable>

speed : @5.0 # sconf set port 4 <@5.0 | @2.5 >

Port 8 : auto # sconf set port 8 <auto | disable | enable>

speed : @5.0 # sconf set port 8 <@5.0 | @2.5 >

Note: A port’s speed configuration becomes effective if the port is

enabled when running the module in unmanaged mode or the port is

forcibly enabled (i.e. not set to ‘auto’) in managed mode.

=> sconf set dtsec4 front

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

Žádné komentáře

Kontron AM4150 U-Boot Bootloader Uživatelský manuál Strana 37