Kontron CG2100 Carrier Grade Server Uživatelský manuál stáhnout pdf (Strana 57)

Installing a Solid-State Drive on the Server Board

1. Remove the back chassis cover. For instructions, see “Removing the Back Cover” in

Section 3.2.

2. Remove the riser card assembly. For instructions, see “Removing the Riser Card

Assembly” in Section 3.2.

3. Remove the processor air duct. For instructions, see “Removing the Processor Air

Duct” in Section 3.2.

4. Locate the white plastic standoff on the server board. (Figure 52, “A”)

5. Insert the drive module onto the server board by connecting the drive module to

the standoff on the server board and the USB connector on the drive module onto the

server board USB header. (“B”)

6. If this is the last task you are performing, re-install the processor air duct, the

riser card assembly, and the back chassis cover. Reconnect all external devices and

the power cord(s).

Figure 52. Installing the SSD on the Server Board

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 109 110

Žádné komentáře

Kontron CG2100 Carrier Grade Server Uživatelský manuál Strana 57