Kontron NSW1U IP Network Server Uživatelský manuál stáhnout pdf (Strana 34)

NSW1U Network Server—Server Installations and Upgrades

Kontron IP Network Server NSW1U

Product Guide, rev. 1.4 December 2009

3.3.2.3 Sparing Mode Memory Configuration

The Memory Controller Hub (MCH) provides memory sparing capabilities. Sparing is a RAS feature

that involves configuring a DIMM to be placed in reserve so it can be use to replace a DIMM that fails.

The following conditions apply:

• DIMMA1 and DIMMB1 must be identical in organization, size and speed.

• DIMMA2 and DIMMB2 must be identical in organization, size and speed.

• DIMMA1 and DIMMA2 need not be identical in organization, size and speed.

• DIMMB1 and DIMMB2 need not be identical in organization, size and speed.

• Sparing should be enabled in the BIOS setup; the BIOS will configure Rank Sparing Mode.

• The larger of the pairs {DIMMA1, DIMMB1} and {DIMMA2, DIMMB2} will be selected as the spare

pair unit.

3.3.3 Installing and Removing Memory DIMMs

The silkscreen on the board for the DIMMs displays DIMMA1, DIMMA2, DIMMA3, DIMMB1, DIMMB2

and DIMMB3, starting from the inside (left side) of the server board. DIMMB3 is the socket closest to

the outside edge of the server board.

3.3.3.1 Installing DIMMs

Reduce the risk of electrostatic discharge (ESD) damage to the processor by doing the following:

• Touch the metal chassis before touching the DIMM or server board.

• Keep part of your body in contact with the metal chassis to dissipate the static charge while

handling the DIMM.

• Avoid moving around unnecessarily.

• Use a ground strap attached to the front panel (with the bezel removed.)

To install DIMMs, follow these steps:

1. Power down the server system and unplug all peripheral devices and the power cable.

2. Remove the chassis cover. For instructions, see Section 3.2.1, “Removing the Chassis Cover” on

page 25.

3. Remove the air duct. For instructions, see Section 3.2.5, “Removing the Processor Air Duct” on

page 27.

4. Locate the DIMM sockets on the server board and select the slot where you want to install the

DIMM. (See Figure 15 and Figure 16.)

5. Open both DIMM socket levers. (Figure 16, “A”)

6. Note the location of the alignment notch. (“B”)

7. Insert the DIMM making sure the connector edge of the DIMM aligns correctly with the slot. (“E”)

8. Using both hands, push down firmly and evenly on the DIMM until it snaps into place and both

levers close. (“C” and “D”)

IMPORTANT: Visually check that each latch is fully closed and correctly engaged with the locking

notch in the DIMM edge.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 109 110

Žádné komentáře

Kontron NSW1U IP Network Server Uživatelský manuál Strana 34