Kontron NSW1U IP Network Server Uživatelský manuál stáhnout pdf (Strana 59)

Kontron IP Network Server NSW1U

December 2009 Product Guide, rev. 1.4

Optional Component Installation Procedures—NSW1U Network Server

3. Fasten the LAN card bracket with both screws. (Figure 42, “A”)

4. Install the riser card assembly back into the server board slot and fasten the thumbscrew. For

instructions, see Section 4.4.4, “Installing the Riser Card Assembly onto the Server Board” on

page 54

5. Guide the cables through the support bracket opening toward the front panel. (“B”).

6. Insert the GbE cable connector from the rear of the front panel into the escutcheon as shown in

Figure 43.

Figure 41. PCI Support Brackets

Figure 42. LAN Card Cables in Support Bracket

AF000888

AF000889

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 109 110

Žádné komentáře

Kontron NSW1U IP Network Server Uživatelský manuál Strana 59