Kontron NSW1U IP Network Server Uživatelský manuál Strana 79

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 110
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 78
Kontron IP Network Server NSW1U
December 2009 Product Guide, rev. 1.4
79
Server Component Replacements—NSW1U Network Server
2. Remove the adhesive cover from the bottom of the insulator.
Place the insulator around the battery, lining up the hole with the riser card assembly hole. See
Figure 61.
5.6.2 Running Setup
3. If this is the last task you are performing, replace the riser card assembly, the processor air duct
and the top cover of the chassis. Reconnect all the external devices and plug in the power cord(s).
4. Run Setup to restore the configuration settings to the RTC. For more information, see Section 6.1,
“Using the BIOS Setup Utility” on page 80.
Figure 61. Attaching the Battery Insulator
TS000418
A
B
Zobrazit stránku 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 109 110

Komentáře k této Příručce

Žádné komentáře