Kontron NSW1U IP Network Server Uživatelský manuál stáhnout pdf (Strana 49)

Kontron IP Network Server NSW1U

December 2009 Product Guide, rev. 1.4

Optional Component Installation Procedures—NSW1U Network Server

4.3 Installing an Optical Device

Caution: The optical device is NOT hot-swappable. Before installing or replacing an optical drive,

you must first take the system out of service, turn off all peripheral devices connected

to the system, turn off the system by pressing the power button, and unplug the power

cord(s) from the system or wall outlet.

To install an optical device in the NSW1U Network Server, you need the carrier tray, interposer board

and the signal and power cables from the accessory kit that shipped with the system.

4.3.1 Removing the Optical Device Filler Panel from the Chassis

1. Remove the chassis cover. For instructions, see Section 3.2.1, “Removing the Chassis Cover” on

page 25.

2. Remove the front bezel. For instructions, see Section 3.2.3, “Removing the Front Bezel” on

page 26.

3. Remove the two screws on the front panel and remove the filler panel from the chassis.

(Figure 28, “A”)

4.3.2 Installing the Optical Device in the Chassis

1. Insert the interposer board connector into the port on the back of the optical drive.

2. Secure the interposer board connection with two screws, as shown. (Figure 29, “A”)

Figure 28. Removing the Optical Device Filler Panel

TS000407

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 109 110

Žádné komentáře

Kontron NSW1U IP Network Server Uživatelský manuál Strana 49