Kontron NSC2U IP Network Server Uživatelský manuál Strana 113

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 152
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 112
Kontron IP Network Server NSC2U
December 2009 Product Guide, rev. 1.4
113
5.4.4 Installing the Drive Bay Assembly
Note: Once the SAS backplane is attached to the drive bay assembly, the HDD drives and an
optical device (or filler blanks if not all slots are used) can be installed into the drive
bay assembly either before or after the assembly is installed in the chassis.
1. Insert the drive bay assembly into the chassis. (Figure 100, “A”)
2. Secure the drive bay assembly to the chassis by fastening the screws on both
sides. (“B”)
3. Reconnect the SFP power cable, the flex cable, and the IDE cable that were
attached to the backplane board before this replacement.
Figure 99. Installing the SAS Backplane Board
TS000316
A
B
Zobrazit stránku 112
1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 151 152

Komentáře k této Příručce

Žádné komentáře