
Kontron IP Network Server NSC2U
December 2009 Product Guide, rev. 1.4
119
4. If the replacement board does not have these components pre-installed and you
are re-using components from the old server board, do the following:
a. Install the processor(s) and heat sink(s). For instructions, see Section 3.4.5.3,
“Installing a New Processor” on page 45.
b. Install all DIMMs. For instructions, see Section 3.4.3, “Installing DIMMs” on
page 41.
c. Install any I/O expansion modules or remote management modules. For
instructions see Section 4.3, “Installing an I/O Expansion Module” on page 55 or
Section 4.4, “Installing Intel® Remote Management Modules” on page 57.
5. Install the PCI riser assembly. For instructions, see Table 4.2.5, “Replacing the
Riser Card Assembly on the Server Board” on page 55.
Figure 104. Installing the Server Board
l
A
TS000537
C
B
Komentáře k této Příručce