Kontron NSC2U IP Network Server Uživatelský manuál stáhnout pdf (Strana 121)

Kontron IP Network Server NSC2U

December 2009 Product Guide, rev. 1.4

121

5. Remove the riser card assembly. For instructions see Section 4.2.2, “Removing the

PCI Riser Card Assembly” on page 53.

6. Insert the tip of a small flat bladed screwdriver, or better yet an equivalent non-

metallic tool, under the tab in the plastic retainer. Gently push down on the

screwdriver to lift the battery.

7. Remove the battery from its socket.

8. Dispose of the battery according to local ordinance.

9. Remove the new lithium battery from its package, and, being careful to observe the

correct polarity, insert it in the battery socket.

10. Re-install the processor air duct, riser card assembly, and the chassis cover.

11. Run Setup to restore the configuration settings to the RTC.

Figure 105. Replacing the Battery

TS000308

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 151 152

Žádné komentáře

Kontron NSC2U IP Network Server Uživatelský manuál Strana 121