Kontron NSC2U IP Network Server Uživatelský manuál Strana 44

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 152
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 43
NSC2U Server—Server Component Installations and Upgrades
Kontron IP Network Server NSC2U
Product Guide, rev. 1.4 December 2009
44
3.4.5.2 Removing a Processor
1. Loosen the four captive screws on the corners of the heat sink with a #2 Phillips
screwdriver. (Section 26, “A”)
2. Twist the heat sink slightly to break the seal between the heat sink and the
processor. (“B”)
3. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink
again.
Note: Do not force the heat sink from the processor. Doing so could damage the processor.
Figure 25. Cautions for Handling Processors
Figure 26. Removing the Heat Sink
TS000279
2
3
1
4
A
B
Zobrazit stránku 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 151 152

Komentáře k této Příručce

Žádné komentáře